In the "Configuration" sub-folder we find the hardware configuration. Below we can see the references:
- Power supply (BMX CPS 2010)
- CPU (BME P58 3020)
- Ethernet module (BME NOC 0301.4): In our application, this module is used to connect to the ASI gateway which collects data from the sensors and to the STB gateway which collects the remote inputs and outputs. It is therefore necessary to configure the DTM which makes it possible to obtain the variables of these two components.
By double clicking on the CPU, you will get the following three tabs :
By clicking on "Channel 0", you can configure the CPU network parameters.
It is possible to see if our power supply is properly sized by right clicking on the CPU image and selecting the option: "Power and I / O balance ...".
By clicking on the "EIO" option in the CPU tree, you will find the characteristics of the Ethernet unit internal to the CPU.
By double clicking on the Ethernet module, you will get the following two tabs.
